How to Replace Beacon 24oz Tumbler Lid
By Ello® | Water Bottles, Food Storage, Travel Mugs & More | Published: 2026-10-29
Category: How-to Guides
Learn how to replace the lid on your Ello Beacon 24oz tumbler. Step-by-step guide for a secure fit, plus tips to avoid leaks and common mistakes.
Quick Answer
Replacing the lid on your Ello Beacon 24oz tumbler is a simple press-fit process. Just align the lid with the tumbler rim, press down evenly, and slide the opening mechanism to confirm it works.
Why the Right Lid Matters
The Beacon 24oz tumbler uses a splash-resistant press-fit lid that slides open for sipping and closed for travel. Using the correct replacement lid ensures the seal stays tight and the sliding mechanism works smoothly. A mismatched lid can cause leaks or make drinking difficult.
The official Replacement Lid - Beacon 24oz Stainless Steel Tumbler is designed specifically for this model. It is BPA-free and features a clear top so you can see inside without opening.
Common Lid Fit Issues
If your new lid feels loose or doesn't snap into place, double-check that you have the correct model. This lid only fits the Beacon 24oz Vacuum Insulated Stainless Tumbler. Using a lid from a different Ello tumbler will not create a proper seal.
Worn or warped tumbler rims can also prevent a good fit. Inspect the rim of your tumbler for dents or damage before installing a new lid.
Steps to Replace Your Beacon 24oz Tumbler Lid
- Remove the old lid: Grip the edges of the current lid and pull upward firmly. If it resists, wiggle it gently from side to side. Do not use tools that could scratch the tumbler rim. Check that the tumbler rim is clean and free of debris before installing the new lid.
- Align the new lid: Hold the Replacement Lid - Beacon 24oz Stainless Steel Tumbler so the slide opening faces the same direction as the tumbler handle or your preferred drinking side. Lower the lid onto the rim, ensuring it sits evenly all around. Misalignment is the most common cause of a poor seal. Take a moment to center the lid before pressing.
- Press down to seal: Place both thumbs on the center of the lid and press down firmly until you hear or feel it snap into place. Run your finger around the edge to confirm it is fully seated. If the lid does not snap, remove it and check for obstructions. Do not force it, as that can damage the lid or tumbler.
- Test the slide mechanism: Slide the opening mechanism back and forth a few times. It should move smoothly without sticking. Fill the tumbler with water, close the slide, and tip it sideways over a sink to check for leaks. A sticky slide or leak indicates the lid is not fully seated or the mechanism is blocked. Remove and reinstall.
Product Details
- Replacement Lid - Beacon 24oz Stainless Steel Tumbler: The Replacement Lid - Beacon 24oz Stainless Steel Tumbler is a splash-resistant press-fit lid with a slide-open mechanism. It is BPA-free and fits only the Beacon 24oz tumbler. This ensures you get a leak-resistant seal and the convenience of one-handed sipping, but you must use it with the correct tumbler model.
Replacement Lid - Beacon 24oz Stainless Steel Tumbler
